ParamQuery grid support forum

General Category => ParamQuery Pro Evaluation Support => Topic started by: rickpqu on August 14, 2015, 02:47:07 am

Title: How to get the unfiltered data (Pro 3)?
Post by: rickpqu on August 14, 2015, 02:47:07 am

Hi, when I used ParamQuery 2.4 Pro, I could get unfiltered data with pqGrid('option', 'dataModel').data. However, with ParamQuery Pro 3, I get filtered data with the same command. How can I access the unfiltered data when the table shows filtered data?

Title: Re: How to get the unfiltered data (Pro 3)?
Post by: rickpqu on August 14, 2015, 02:51:02 am

Nevermind. I found that dataModel.dataUF has unfiltered data.

Title: Re: How to get the unfiltered data (Pro 3)?
Post by: rickpqu on August 14, 2015, 03:09:07 am

Actually, dataUF was not what I was looking for. If my whole data has four rows 1, 2, 3, and 4, and after filtration only 2 and 3 are left, dataUF has 1 and 4. However, what I am looking for is an object that contains all of 1, 2, 3, and 4, in their original order. Is it possible to retrieve this object from a grid?